Type 'enable' (without the quotes) at the prompt and press 'Enter.' Type the enable password for the router and press 'Enter' to enter enabled mode.Ĭopy the new IOS to flash memory. The actual prompt will vary if you have renamed the router in a previous configuration session.

After the router runs through its startup diagnostics, you should see the 'router>' prompt. Configure the terminal session settings as follows:ĩ600 bits per second 8 data bits 0 parity bits 1 stop bit No flow controlīoot the router by connecting the power cable to the router and a standard wall outlet. Use HyperTerminal, PuTTy or any other terminal emulator to connect to the router.

The cable has a DB-9 serial connector on one end and a RJ-45 network jack on the other. You must have a Cisco customer account in order to access and download new IOS images, and the image you download must specify that it is for your router model.Ĭonnect your computer to the router via the console port, using the blue console cable that typically comes with the router. Select an IOS image from the Cisco customer site and download it to your TFTP server's outbound directory.

Configure the directory for outbound files as per the instructions for the TFTP server you downloaded. Your computer will act as a server and the Cisco router will act as a client.

Configure the TFTP software to run as a server, rather than as a client.

Download cisco ios tftp server